Home > Alternators > Alternator Wiring
Sort By:
Page of 1
Delco 10Si Alternator plug 3 G Ford Alternator plug connector Delco CS130 Alternator plug
3 G Ford Alternator Plug
Our Price: $19.95
Delco Alternator 2 wire connection plug

The alternator plug is a wiring adapter that allows easy installation of a 10Si alternator 3 wire connection. The plug is designed to snap into the 2 pin connector in the back of 10Si style internally regulated alternator. This plug along with the 10AWG hot wire to your battery is all you need to connect your alternator into your vehicle.

There is a diode located in the white feed wire to prevent voltage feedback and also allows shutting off engine in older vehicles.

The wire gauge is 16AWG.




3 G Ford Alternator Pigtail use when connecting Ford 3 G alternator.

See below to add 10AWG alternator output wire.








Delco CS130 Alternator plug used in 2 wire connection. (Alternator not included)

The (Delco Alternator) plug is a wiring adapter that allows easy installation of an alternator 2 wire connection when converting from a generator. the plug is designed to snap into the connector at the back of Delco Cs130 internal regulated alternators. This wire along with the output wire to your ammeter is all you need to connect up an alternator when doing a conversion.

The special feature of our plugs is a diode that prevents voltage from your alternator to enter your ignition system allows shutting down of your engine when using the original on-off ignition switch. This plug adaptor acts as a source of current to excite or turn on the alternator at low RPM.

Modern cars with alternators idle faster than the older engines, most alternators are set to turn on around 1,200 RPM, older engines idle in the 600-800 RPM range, this plug tells the alternator to turn on at low RPM.