1948-1953 Ford Flathead Six Cylinder H Series 12V Conversion Kit.
Note: this kit will not fit earlier G series engines built prior to 1948.
Included in this conversion kit for your flathead six cylinder Ford; 12 volt 63 amp 10Si alternator properly clocked to fit flathead six cylinder bracket that mounts the alternator in the same position as the original generator.
Ignition Coil with coil bracket, Headlight Relay, Horn Relay, Oil Gas Temp Gauge Regulator (allows use of original 6v gauge sending units), Start Solenoid, 3 wire DA plug and 10 AWG alternator to battery connection wire and full set of instructions.
Note: Select the correct size pulley for the belt on your car or truck.
1948-1953 trucks used 3/4" generator pulley to fit the wide belt. 3/4" pulley will also fit 5/8" belts
1948-1950 cars used the same 3/4" pulley. 3/4" pulley will also fit 5/8" belts
1951 Cars used the narrow 3/8" belt.
Kit fits H Series Ford engines built between 1948-1953. Alternator bracket will not fit G series engines made between 1940-1947 due to the location of the distributor.
The H series engine is easily distinguished from the G Series by distributor location....the new Load-a-matic distributor on H series engines is mounted on the driver side of the cylinder block near the middle of the engine.
See other optional items listed below.
1 Year Warranty Made In USA