Home > Shop > Shop By Category > Switches Relays Solenoids >

Borg Warner Overdrive R-10 R11 Solenoid 6 volts Remanufactured
Borg Warner Overdrive Solenoid 6 volts Reman


 
Remanufactured
Our Price: $284.95

Availability:: Currently Unavailable
Product Code: ODSL6R


Qty:  
Description Reviews
 
Borg Warner R-10 R-11 Overdrive Solenoid 6 Volts Remanufactured

These solenoids are typically original solenoids that have been remanufactured and fully tested in our facility. Comes with 90 day warranty.

This is the same solenoid used by all eleven of the car companies that offered the Borg Warner electric overdrive as an option from the late 1930's through the early 1960's. This solenoid will fit standard Borg Warner overdrive applications with a shaft length of 1", measured from the tip of the shaft to the edge of the alignment flange. (lay your ruler on top of the shaft and measure from the ball end to the edge of the casting). All standard overdrive-solenoids will measure 1". Wagons, convertibles and Lincoln's will measure 1.5 inches and a few odd applications will measure 1.25 inches or longer.


This solenoid fits the STANDARD 1" applications. Please check you shaft length before ordering. MEASURE SHAFT LENGTH BEFORE ORDERING TO MAKE SURE YOURS IS 1 INCH IN LENGTH.
Click for wire diagram
Solenoid wiring terminals with the solenoid in hand and the shaft facing out in front of you, the right hand terminal is number four and connects to the relay. The left hand terminal connects to the kick down switch. A small amount of solenoids had a third wire that was a ground if yours is one of those check your shop manual and it will confirm where the third wire goes. Most solenoids had screw in terminals, a few had internal connections with wires coming out of the solenoid. Wiring connections for both are the same.

When changing the solenoid we recommend always changing the seal in the transmission. This will prevent oil from entering into your new solenoid.
There is a seal in the solenoid itself that can;t be changed in the field. The seal that you can change is in the transmission where the shaft goes through.


SD01 Borg Warner reducer driver
Installation Instructions

Add These Options To The Kit Simply Check the Item
Borg Warner R10 R11 Overdrive Manual Control Cable Borg Warner Overdrive Solenoid Shaft Seal Borg Warner R-10-R-11 Overdrive Solenoid 12 Volts Borg Warner R10 R11 Overdrive Kick Down Throttle Switch
Our Price: $59.95

Add
Our Price: $8.95

Add
Our Price: $384.95

Add
Our Price: $29.95

Add
Borg Warner Overdrive Push Pull Control Cable Borg Warner Overdrive Solenoid Shaft Seal R-10 R-11 Borg Warner R-10 R-11 Overdrive Solenoid 12 Volts Borg Warner R10-R11 Overdrive Kick Down Switch
Borg Warner Overdrive R-10 R11 Solenoid 6 volts Borg Warner R10 R11 Overdrive Guide
Our Price: $384.95

Add
Our Price: $15.00

Add
Borg Warner Overdrive Solenoid 6 volts Official Guide to the Borg-Warner Overdrive